Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering (JSME) - Articles List

Home Articles List

Articles in Press

Current Issue

Journal Archive

Volume & Issue: Issue 3

Persian
1		Numerical investigation of heat transfer and laminar Water-Al2O3 ‎nanofluid flow in a rectangular Rib-Microchannel
	Page 391-408
	Davood Toghraee; Arash Karimipour; OmidAli Akbari; Majid Zaringhalam; Habibolah Alipour
	Show Article \| PDF (2358 K)

2		The Parameters Investigation and Hardness Optimization of A380 Aluminum Alloy produced by Mechanical Vibrator
	Page 409-418
	Saeed Ehteramian Haghighi; Amin Kolahdooz; Majid Karimian
	Show Article \| PDF (833 K)

3		The numerical study of heat transfer of water-TiO2 nanofluid in the ‎triangular microchannels with semiattached and offset mid-truncated ‎rib,s‎
	Page 419-430
	Mousa Heydari; Davood Toghraie; Omid Ali Akbari
	Show Article \| PDF (940 K)

4		An experimental investigation on effect of hybrid solid MWCNTs and MgO on thermal conductivity of ethylene glycol
	Page 431-440
	Masoud Vafaie; Masoud Afrand
	Show Article \| PDF (1260 K)

5		Free vibration Study of simply supported cylindrical laminateds panels with piezoelectric layer
	Page 441-454
	Mostafa Moattari; Farzan Barati
	Show Article \| PDF (905 K)

6		A new plan to connect aluminum tubes of subsurface structures
	Page 455-466
	Gholamreza Mazruei; ali Heidari
	Show Article \| PDF (1128 K)

7		Experimental Study for Addition Rough Surfaces on a Vehicle Floor Body and Comparison of Aerodynamics Coefficient
	Page 467-478
	Koorosh Rayzan; Ahmad Keshavarzi
	Show Article \| PDF (752 K)

8		Ti-6Al-4V Synthesized by Mechanical Alloy Method and Mechanical and Bioactivity Properties of Ti-6Al-4V/HA-Clay Nano composite
	Page 479-490
	Mohammad ali Motallebi; Ebrahim Karamian; Magid Karimian
	Show Article \| PDF (1462 K)

9		Simulation microcapsules reinforced by carbon nanotubes contained in a capsule-based self-healing materials
	Page 491-508
	Jafar Eskandari Jam; Fatameh Khani; Mahmood Farhadinia
	Show Article \| PDF (1202 K)

10		Numerical study on the effect of hammering pressure on thickness reduction in hot tube metal gas forming process
	Page 509-516
	Ali Talebi Anaraki; Mohssen Loh-Mousavi
	Show Article \| PDF (764 K)

11		Failure Mechanisms Investigation in Thermal Barrier Coatings under Isothermal and Non-sothermal Fatigue Loadings using Design of Experiments
	Page 517-530
	Mohammad Azadi; G.H. Farrahi
	Show Article \| PDF (1154 K)

12		Dynamic modeling and nonlinear vibration simulation of piezoelectric micro-beam in self sensing mode of atomic force microscope
	Page 531-542
	Ahmad haghani; Reza Qaderi
	Show Article \| PDF (1225 K)

13		AZ31/HA-Zeolite Nano Crystalline Biocomposite Fabricated by Mechanical Alloying and Powder Metallurgy: Mechanical Properties
	Page 543-552
	Hassan Gheisari; Ebrahim Karamian; Mohammad Barati Sede
	Show Article \| PDF (1000 K)

14		Investigation into Aging Effect on Wear Behavior of Titanium Alloy
	Page 553-568
	Amir Qysryan; Mahmood Abasi
	Show Article \| PDF (1837 K)

15		Experimental, numerical and analytical investigation of the new metal/composite Comeld Joint
	Page 569-586
	Mohammad Moein Seif; khodadad vahedi; erfan Ghiasi; Rouhollah Hosseini
	Show Article \| PDF (2549 K)

Journal of Simulation and Analysis of Novel Technologies in Mechanical Engineering (JSME) - Articles List

Persian

Numerical investigation of heat transfer and laminar Water-Al2O3 ‎nanofluid flow in a rectangular Rib-Microchannel

The Parameters Investigation and Hardness Optimization of A380 Aluminum Alloy produced by Mechanical Vibrator

The numerical study of heat transfer of water-TiO2 nanofluid in the ‎triangular microchannels with semiattached and offset mid-truncated ‎rib,s‎

An experimental investigation on effect of hybrid solid MWCNTs and MgO on thermal conductivity of ethylene glycol

Free vibration Study of simply supported cylindrical laminateds panels with piezoelectric layer

A new plan to connect aluminum tubes of subsurface structures

Experimental Study for Addition Rough Surfaces on a Vehicle Floor Body and Comparison of Aerodynamics Coefficient

Ti-6Al-4V Synthesized by Mechanical Alloy Method and Mechanical and Bioactivity Properties of Ti-6Al-4V/HA-Clay Nano composite

Simulation microcapsules reinforced by carbon nanotubes contained in a capsule-based self-healing materials

Numerical study on the effect of hammering pressure on thickness reduction in hot tube metal gas forming process

Failure Mechanisms Investigation in Thermal Barrier Coatings under Isothermal and Non-sothermal Fatigue Loadings using Design of Experiments

Dynamic modeling and nonlinear vibration simulation of piezoelectric micro-beam in self sensing mode of atomic force microscope

AZ31/HA-Zeolite Nano Crystalline Biocomposite Fabricated by Mechanical Alloying and Powder Metallurgy: Mechanical Properties

Investigation into Aging Effect on Wear Behavior of Titanium Alloy

Experimental, numerical and analytical investigation of the new metal/composite Comeld Joint